The principle in three questions
Sizing a solar installation means answering three questions in this order: how much energy do you use per day, how much reserve do you need to last without sun, and how much panel power is needed to recharge it all.
Energy is counted in watt-hours (Wh). A 50 W device running for 4 hours uses 200 Wh. It is the only unit you need to get started.
Step 1: add up your daily needs
List each device, its power in watts and its hours of use per day. Multiply, then add up. For a compressor fridge, do not count 24 hours at full power: the motor stops and restarts. Dometic publishes the average consumption of its electric cool boxes in amp-hours per hour; for two models this gives about 1 to 1.6 Ah per hour at 12 V, with 32 °C outside.
The values below are orders of magnitude. They help you get started; the rating plate or data sheet of your devices remains the reference.
| Device | Power (approx.) | Use per day | Energy per day (approx.) |
|---|---|---|---|
| 12 V compressor fridge | 12 to 20 W on average | 24 h | 250 to 450 Wh |
| LED lighting | 20 W | 4 h | 80 Wh |
| Laptop | 45 W | 4 h | 180 Wh |
| 4G router | 10 W | 12 h | 120 Wh |
| Phones and tablet | 10 to 12 W | 2 to 3 h | 30 to 50 Wh |
| Water pump | 50 W | about 10 min | 10 Wh |
| Diesel heater (electricity only) | 20 W at steady state | 8 h | about 150 Wh |
Step 2: a worked example
With a fridge (300 Wh), LEDs (80 Wh), a laptop (180 Wh), a router (120 Wh), phones (30 Wh), the pump (10 Wh) and a Diesel heater (150 Wh), you reach about 870 Wh per day. This is an example, not an average profile: redo the calculation with your own devices.
To last two days without recharging, you need about 1,740 Wh usable. An AGM battery should only be discharged to about half to last (according to Victron, a 200 Ah lead battery offers barely 100 Ah usable). A LiFePO4 battery can be discharged much more deeply, to 80% or more depending on the manufacturer. See our guide on LiFePO4 versus AGM for the details.
Example: 1,740 Wh usable at 80% depth of discharge means about 2,175 Wh of capacity, or about 170 Ah at 12.8 V (2,175 divided by 12.8).
Step 3: choosing the panel power
A panel only reaches its rated power (in Wp, watts-peak) under laboratory conditions. On a van roof, with heat, a flat orientation, shade, cables and the charge controller, allow for about 60 to 75% of the stated power. This is a common order of magnitude, not a guarantee.
The formula: daily energy divided by (peak sun hours multiplied by efficiency). One peak sun hour equals 1 kWh of light received per square metre. PVGIS, the European Commission’s tool, gives the averages for every location.
With 870 Wh per day, 6 peak sun hours and 70% efficiency, you need about 870 / (6 × 0.7) = 207 W of panels. With 1 peak sun hour in winter, you would need about 1,240 W, which will not fit on a van roof.
Sunshine changes everything between summer and winter
The table gives averages in peak sun hours per day on a horizontal plane (2005 to 2020 period, PVGIS source). Our calculator uses the same data for each month.
| City | June (h/day) | December (h/day) |
|---|---|---|
| Lille | 5.52 | 0.71 |
| Paris | 5.73 | 0.9 |
| Lyon | 6.37 | 1.13 |
| Bordeaux | 6.14 | 1.28 |
| Marseille | 7.55 | 1.67 |
What to do in winter?
The December figures show that in the north of France the sun is not enough to cover daily use. Three solutions are often combined: reduce consumption (a smaller fridge, fewer screen recharges), charge while driving with a charger fed by the engine’s alternator (DC-DC charger), or plug into the 230 V mains at a campsite from time to time.
The DC-DC charger and any fixed wiring call for properly sized fuses and cables: read our guide on electrical safety and have the installation checked by a professional.
The other components to plan for
A charge controller (ideally MPPT) between the panels and the battery: never connect a panel directly to the battery, as Victron expressly advises against it. Fuses on the positive wire, cables of the right cross-section, a battery isolator, and, if you want 230 V, an inverter.
Also allow some margin: the battery ages, clouds last longer and needs always grow.
- The charge controller must accept the voltage of the panels in series.
- Each device connected to the battery needs its own fuse.
- For 230 V, consult a professional.
Sources
- PVGIS, European Commission tool (solar radiation)
- Dometic, CFX3 support: compressor fridge consumption
- Victron Energy, blog: lithium-ion (LFP) batteries versus AGM
- Victron Energy, Wiring Unlimited: DC wiring
Safety. This guide is for information only and replaces neither the manufacturer's instructions nor a professional's advice. For 230 V, high currents and any fixed installation, call a qualified professional.
Also worth reading
- Vans and motorhomes: electrical safety and rules to know
- LiFePO4 or AGM: which battery for nomadic use?
- How Solanomad selects and presents products