Guide

Portable power station or fixed installation: which for a van?

Portable power station or fixed installation: weight, expandability, power and use cases compared, with figures from manufacturers' datasheets.

Updated on 22 November 2026.

The short answer

Choose a portable power station if you want electricity right away, with no wiring, for weekends, a car or use away from the vehicle. Choose a fixed installation if you live in the van, if your daily needs exceed about 1 kWh or if you want to be able to expand the system later.

Both are valid. The difference has less to do with technology than with how you use the vehicle: occasionally or every day, and how much you like to tinker.

What each of the two solutions is

A portable station combines in one case a battery, a 230 V inverter, a solar controller and USB and 12 V sockets. You connect it to panels or to the mains, and use it immediately.

A fixed installation separates these elements: a battery, a charge controller for the panels, possibly an inverter, fuses, a battery isolator and cables. Each part can be chosen, replaced and added to independently, but the whole must be wired correctly.

Comparison criteria

The table compares the two approaches on criteria you can check yourself on the datasheets. It stays general: the detail depends on the models.

CriterionPortable stationFixed installation
Getting startedImmediate, no toolsNeeds wiring, fuses, often a professional
Moving itComes out of the vehicle, also useful at homeStays in the vehicle
ExpansionLimited: expansion possible only on some modelsBatteries and panels can be added within the limits of the controller and the battery
Maintenance and repairA single block: often a return to the manufacturerEach part is replaced separately
IntegrationBulky in a small spaceFits into unused spaces
Risk of errorLower: the whole is designed to work togetherHigher: cross-section, fuse and compatibility to check

Weight and energy: datasheet figures

As well as the battery, a station carries an inverter and a controller, which increases the weight for the same energy. A battery alone is lighter, but you must add the rest.

The table uses the manufacturers' datasheets. The Wh per kg ratio is a simple calculation (energy divided by weight); it says nothing about lifespan or quality.

Product (manufacturer datasheet)CapacityWeightWh per kg (calculated)What it includes
EcoFlow Delta 2 station1,024 Wh12 kgabout 85battery, 230 V (1,800 W), solar controller up to 500 W
Bluetti AC180 station1,152 Wh16 kgabout 72battery, 230 V (1,800 W), solar controller up to 500 W
Bluetti AC200L station2,048 Wh28.3 kgabout 72battery, 230 V (2,400 W), solar controller up to 1,200 W
Victron Smart 12.8 V 100 Ah battery1,280 Wh14 kgabout 91battery only, no inverter or controller
LiTime 12 V 100 Ah battery1,280 Wh9.53 kgabout 134battery only with built-in BMS

What they power, according to the datasheet

A station like the Delta 2 states 1,800 W at 230 V and a 12.6 V, 10 A output, or about 126 W: enough for a compressor fridge, a router and chargers. The smaller Bluetti EB3A states 268 Wh and 600 W: sufficient for recharging devices, not for a fridge all day.

These figures show the main trade-off: capacity in watt-hours determines how long you last, power in watts determines what you can plug in at the same time. A fridge using 300 Wh per day (an example from our sizing guide) drains a 1,024 Wh station in a little over three days without sun, in theory and without counting losses.

On the charging side, look at the maximum solar power accepted: 200 W for the EB3A, 500 W for the Delta 2 and the AC180, 1,200 W for the AC200L according to their datasheets. This limits how many panels are useful. In winter, the real limit is often sunshine, not this ceiling: see our guide on solar in winter.

Three use cases

To fix ideas, here are three typical situations and the solution that generally suits them. They are guidelines, not rules.

The trap to avoid: mixing without checking

Connecting a station to the van's 12 V installation, or panels to a battery without a controller, exposes you to overcurrents. Victron expressly advises against connecting a panel directly to a battery. Read the manual of each appliance and respect the maximum voltages and currents stated.

The high currents of lithium batteries, and the 230 V of an inverter, justify having any fixed installation checked by a professional. This guide does not guarantee the compliance of any installation. For the general framework, read our guide on regulations and electrical safety.

How to decide

Ask yourself three questions (the thresholds given are simple guidelines, not rules). How many watt-hours do you use per day: below about 500 Wh, a station is often enough; above 1 kWh, a fixed installation becomes more logical. Will you use the system away from the vehicle: if so, the station has an advantage. Are you ready to do the wiring or pay someone to do it: if not, the station avoids the problem.

First calculate your needs with our autonomy calculator. The figures in this guide are from manufacturers' datasheets; compare prices and upgrade options at the time of purchase, as they change.

Sources

Safety. This guide is for information only and replaces neither the manufacturer's instructions nor a professional's advice. For 230 V, high currents and any fixed installation, call a qualified professional.

Also worth reading

Calculate my needs

Transparency. Solanomad is funded by affiliate marketing, but this version of the site contains no partner or merchant links for now: no commission is linked to your clicks here. Learn more.