The short answer
In winter, a van panel in France produces 4 to 8 times less than in June: it generally no longer covers daily use, except in the south. You need to plan something else: charging from the engine, plugging into the mains from time to time, a larger battery and reduced consumption.
Cold raises a second question: a lithium battery cannot be charged at just any temperature. The two issues, little sun and a cold battery, combine.
What the sunshine figures say
The table uses PVGIS averages (period 2005 to 2020) in hours of full sun per day on a horizontal plane, for December and June, with the ratio between the two calculated by us.
| City | December (h/day) | June (h/day) | June divided by December |
|---|---|---|---|
| Lille | 0.71 | 5.52 | about 7.8 |
| Berlin | 0.56 | 5.72 | about 10 |
| Paris | 0.9 | 5.73 | about 6.4 |
| Lyon | 1.13 | 6.37 | about 5.6 |
| Bordeaux | 1.28 | 6.14 | about 4.8 |
| Marseille | 1.67 | 7.55 | about 4.5 |
| Madrid | 2.09 | 7.62 | about 3.6 |
A worked example
Take a 200 W panel, with the overall efficiency of about 70% used in our sizing guide. In Paris in December, it gives 200 × 0.7 × 0.9, or about 126 Wh per day. In Marseille, 200 × 0.7 × 1.67 gives about 234 Wh. In Madrid, about 293 Wh.
A compressor fridge uses something like 250 to 450 Wh per day according to our sizing guide, and a complete van example reaches about 870 Wh. Even in Madrid, the panel alone does not cover this example in December. To cover it in the Paris region, you would need more than 1,200 W of panels, which will not fit on a van roof.
These values are averages over several years: a month can be worse. They assume a flat panel with no shade, and do not account for snow or persistent cloud cover.
Tilt and orientation
The figures in the table apply to a horizontal plane, which corresponds to a panel lying flat on the roof. In winter the sun is low: a panel tilted towards the south can receive noticeably more radiation than a flat one. A folding panel can be set on a slope and turned towards the sun, which a roof panel cannot do.
PVGIS lets you simulate the effect of a tilt for a specific place. Use it to estimate the gain before investing in a tilting mount. Shade from the vehicle, trees or buildings matters more in winter, because the sun is low: an open parking spot often makes more difference than an extra panel.
Lithium battery and cold
Victron states, for its Smart lithium batteries, that charging is possible from 5 °C to 50 °C and discharging from −20 °C to 50 °C. Below 5 °C, charging is therefore blocked by the battery, including from the panels. Other manufacturers give other ranges: a Renogy datasheet states charging from −20 to 55 °C for a model with self-heating, a Redodo datasheet charging from 0 to 50 °C for a model without heating.
In practical terms, if your battery is in an unheated compartment and the temperature is below zero, your panels may charge nothing. Look at the charging range on the datasheet, place the battery in the heated area of the vehicle if possible, or choose a model with built-in protection or heating. For lead batteries (AGM), see our LiFePO4 and AGM comparison.
Another, more technical point: a panel's voltage rises when it is cold. Keep a margin below your controller's maximum input voltage (for example 75 V or 100 V depending on the datasheet models) and do not size the series wiring right at the limit.
Reduce needs before adding panels
Adding 100 W of panels in December in Paris brings about 63 Wh per day according to the calculation in the previous table. Saving 63 Wh means, for example, switching off a 10 W router for six hours, or cutting 20 W lighting by three hours. In winter, reducing consumption almost always costs less and weighs less than adding panels. Start by listing your appliances with our autonomy calculator, spot the most power-hungry, then decide.
Other energy sources in winter
When the sun is missing, three sources take over. They add up, and none is perfect.
- The engine: a DC-DC charger links the alternator to the battery. The Victron Orion XS 12/12-50A is rated at up to 50 A at 12 V, or about 600 W at most. An hour on the road can therefore bring several hundred watt-hours depending on the installation, which quickly makes up for a dark day.
- The mains: a 230 V charger plugged in at a campsite or at a friend's. For a 16 A campsite connection, Victron cites an available power of about 3,680 W.
- Consuming less: a smaller fridge, LEDs, fewer screen recharges, a diesel heater with low electrical consumption rather than an electric radiator.
Sizing the battery for winter
For the winter period, Victron recommends planning for three days of autonomy, because weather and season weigh heavily on solar charging. With 870 Wh per day, three days call for about 2,610 Wh usable, or about 3,260 Wh of lithium capacity if you count on 80% being usable. That is more than is installed in many vans: hence the value of reducing needs.
Whatever the choice, do not rely on optimistic figures. If you spend the winter in the mountains or the north, charging from the engine and the mains must be part of the plan from the start. Have chargers and high-current cables fitted by a professional, and check fuses and cable sizes: see our guide on regulations and electrical safety. This guide does not guarantee the compliance of any installation.
Sources
- PVGIS, European Commission tool (solar radiation)
- Victron Energy, article: sizing the battery bank of a recreational vehicle
- Victron Energy, Smart lithium battery: safety precautions (temperature ranges)
- Renogy, 12 V 100 Ah LiFePO4 Pro battery with self-heating
- Redodo, 12 V 100 Ah Group 24 battery datasheet
- Victron Energy, Orion XS DC-DC battery chargers
- Victron Energy, help me choose: inverters and chargers (16 A connection)
Safety. This guide is for information only and replaces neither the manufacturer's instructions nor a professional's advice. For 230 V, high currents and any fixed installation, call a qualified professional.