The short answer
Panel power depends on what you consume, not on the size of the van. For typical summer use, many vans get by with 100 to 400 W of panels; in winter, no roof is enough if you consume a lot. Here is how to find your figure.
The calculation fits on one line: panel power (in Wp) = energy used per day (in Wh) divided by (hours of full sun multiplied by 0.7). The 0.7 is a loss coefficient explained below.
Step 1: know your daily consumption
List your appliances, their power in watts and their hours of use, then add up the watt-hours (Wh). A 50 W appliance running for 4 hours uses 200 Wh. Our guide on sizing a converted van details the method, and our autonomy calculator does it for you.
The fridge is often the biggest item: a 12 V compressor fridge uses about 1 to 1.6 Ah per hour according to Dometic datasheets, or about 290 to 450 Wh per day. Our guide on 12 V fridge consumption explains the conversion.
Step 2: hours of full sun
One hour of full sun corresponds to 1 kWh of light received per square metre. It is not the length of the day: a summer day can have 6 hours of full sun, a December day in Lille less than one hour. PVGIS, the European Commission's tool, gives these averages for each place and each month.
Averages on a horizontal plane (period 2005 to 2020, source PVGIS, used in our calculator):
| City | June (h/day) | December (h/day) |
|---|---|---|
| Lille | 5.52 | 0.71 |
| Paris | 5.73 | 0.9 |
| Lyon | 6.37 | 1.13 |
| Bordeaux | 6.14 | 1.28 |
| Marseille | 7.55 | 1.67 |
Step 3: the loss coefficient
A panel only reaches its stated power (in Wp, watts-peak) under laboratory conditions. On a van roof, heat, the flat orientation, shade, cables and the controller cost part of the energy. We use about 0.7, meaning 60 to 75% of the stated power: this is a common order of magnitude, not a guarantee.
If you drive a lot and the van is in shade or facing north, count on the low end of the range.
Three worked profiles
The three profiles below are examples, not averages. The average profile uses the 870 Wh per day from our sizing guide. Calculation: Wh per day divided by (hours of sun x 0.7). The values are rounded and assume a flat panel with no shade.
| Profile | Energy per day | Summer: 6 h of sun | Spring or autumn: 3 h | Winter: 1 h |
|---|---|---|---|---|
| Light: fridge only and a little lighting | about 400 Wh | about 95 W | about 190 W | about 570 W |
| Average: fridge, laptop, router, LEDs | about 870 Wh | about 207 W | about 415 W | about 1,240 W |
| Heavy: more cooking or work | about 1,500 Wh | about 360 W | about 715 W | about 2,140 W |
What the table shows
In summer, 100 to 400 W of panels are enough for these three profiles. In winter, the power needed becomes unrealistic on a roof: that is normal, and it is why you size not for the worst month but for the period when you travel. If you live in the van all year, plan for other sources: charging from the engine with a DC-DC charger, plugging into the mains at a campsite, or lowering consumption.
Round up to the next power: the battery ages and needs almost always grow.
The roof limit
Usable power is also limited by the available surface. You must deduct the skylight, aerials and roof bars, and leave a little room for ventilation. Note the exact dimensions from the panel's datasheet before buying: for the same power, formats vary.
Do not fit more panels than the controller accepts: check its maximum input voltage and charging current. Our guide on choosing a controller details this point. For fitting and fuses, see the wiring guide.
Wiring high currents and 230 V is risky work: have your installation checked by a professional. This guide does not recommend any product and does not guarantee compliance.
- Measure the free roof before choosing.
- Check the voltage and current accepted by the controller.
- Plan a fuse between the panel array and the controller, according to local rules (Victron).
A complete example and common questions
Take a van used from May to September around Lyon. The average profile uses about 870 Wh per day. In June, Lyon receives 6.37 hours of full sun per day according to PVGIS. The calculation gives 870 / (6.37 x 0.7) = about 195 W: a 200 W array covers consumption in June, with no margin.
In September or April, the sun is lower. With about 3 hours of full sun, you would need about 415 W. With 200 W, recharging will take two days: either you consume less, or you plug the van in from time to time, or you raise the power if the roof allows it. This example is not a purchase recommendation: it shows why the same van can be well equipped in July and under-equipped in November.
Do you need more panels if the battery is big? No: the battery stores, the panel produces. A big battery helps you get through days without sun, but only the panels (or another charger) fill it.
Can you tilt the panels? A panel tilted towards the sun produces more, especially in winter, but most vans fix the panels flat on the roof. Mobile or folding panels can be oriented better: see our guide on use without a vehicle.
Do you need to allow for clouds? PVGIS averages already include the average cloudiness of the place. An exceptionally grey month will fall short, which is why a margin is useful.
Sources
- PVGIS, European Commission tool (solar radiation)
- Dometic CFX3 25: product sheet, consumption at 32 °C
- Dometic CFX3 95DZ: product sheet, consumption at 32 °C
- Victron Energy, Wiring Unlimited: DC wiring
Safety. This guide is for information only and replaces neither the manufacturer's instructions nor a professional's advice. For 230 V, high currents and any fixed installation, call a qualified professional.