The short answer
A 12.8 V, 100 Ah lithium iron phosphate (LiFePO4) battery stores about 1,280 Wh, and provides about 1,000 Wh of usable energy if you keep to an 80% discharge. That is enough to run a 12 V fridge, a few LED lights, a router and a laptop for about a day.
The calculation: volts x amp-hours
A battery's energy is calculated by multiplying its voltage by its capacity: watt-hours (Wh) = volts x amp-hours (Ah). According to Victron, a LiFePO4 cell has a nominal voltage of 3.3 V; manufacturers of 12 V batteries most often quote 12.8 V, which is 4 cells of 3.2 V in series.
For 12.8 V and 100 Ah: 12.8 x 100 = 1,280 Wh. With the older convention of a 12 V nominal voltage, you get 1,200 Wh: the difference comes only from the voltage used. Always read the datasheet, which gives the watt-hours or the nominal voltage.
Depth of discharge
Not everything that is stored can be used. Victron states that the practical depth of discharge of a lead-acid AGM battery is 50%, and that of a LiFePO4 battery is 80%. Your manufacturer may allow more; its figure is the one to follow, because lifespan depends on depth of discharge.
With 80%: 1,280 x 0.8 = 1,024 Wh usable. By comparison, a 12 V, 100 Ah AGM battery (1,200 Wh) would offer only about 600 Wh at 50%. Our LiFePO4 versus AGM guide covers the comparison in detail.
| 100 Ah battery | Energy stored (approx.) | Discharge used (Victron) | Usable energy (approx.) |
|---|---|---|---|
| LiFePO4 12.8 V | 1,280 Wh | 80% | 1,020 Wh |
| AGM 12 V | 1,200 Wh | 50% | 600 Wh |
What 1,000 Wh will power
The power figures below are orders of magnitude: the rating plate of your own appliances is the reference. The fridge is calculated from Dometic datasheets (about 1 Ah per hour at 12 V and 32 °C, or about 290 Wh per day). The total of 870 Wh comes from the example in our sizing guide.
A 100 Ah battery therefore covers one day of this average profile, not two. To last two days without sun, you need roughly double.
| Appliance | Energy per day (approx.) |
|---|---|
| 12 V compressor fridge | 250 to 450 Wh |
| LED lighting (20 W, 4 h) | 80 Wh |
| Laptop (45 W, 4 h) | 180 Wh |
| 4G router (10 W, 12 h) | 120 Wh |
| Total of the average profile in the van guide | about 870 Wh |
| Usable share of a 100 Ah LiFePO4 battery | about 1,020 Wh |
Charging the battery: current and time
Victron states that a 200 Ah lithium battery can accept up to 500 A, but recommends 0.5C or less for lifespan, which is 50 A for 100 Ah. Your manufacturer may set a different limit: check the datasheet.
Example: recharging 80 Ah (from 20% to 100%) at 20 A takes about 4 hours. With a 200 W panel at 70% efficiency, or about 140 W, you need about 1,024 / 140 = 7 hours of full sun. Solar charging time depends on the season: see our guide on panel power.
Compatibility and safety
The charge controller, charger and inverter must support lithium chemistry: charging voltages differ from those of lead. A lithium battery must have a BMS (protection electronics). According to Victron, at least one fuse in the circuit must have a breaking capacity greater than or equal to the battery's maximum short-circuit current; this is an essential safety requirement.
Cold deserves attention: charging is often blocked below about 0 to 5 °C depending on the model. For high currents and 230 V, call a professional. This guide does not recommend any product and does not claim that any battery is compliant.
How many days of autonomy, and common questions
The number of days is calculated by dividing the usable energy by the daily consumption. With 1,024 Wh usable and a light profile of 400 Wh per day, you get about 2.5 days without any recharging. With the average profile of 870 Wh, about 1.2 days. With a profile of 1,500 Wh, about 0.7 day: you would need more than one 100 Ah battery.
These figures assume a new battery, fully charged and at ordinary temperature. A battery ages: its capacity falls slowly with cycles, and a cold battery delivers less. Keep a margin rather than calculating too tightly.
Can you connect two 100 Ah batteries together? Yes, in parallel (same voltage, capacities added), but only with identical batteries and following the manufacturer's instructions. Mixing ages or models is best avoided.
What is a BMS? It is the protection electronics of a lithium battery: it monitors voltage, current and temperature, and cuts off if there is a problem. It does not replace fuses.
Are amp-hours enough to compare batteries? No: compare in usable watt-hours, because the nominal voltage differs from one chemistry to another.
| Profile | Consumption per day | Autonomy with 1,024 Wh usable (approx.) |
|---|---|---|
| Light | 400 Wh | 2.5 days |
| Average | 870 Wh | 1.2 days |
| Heavy | 1,500 Wh | 0.7 day |
What to remember
Remember three figures for a 100 Ah LiFePO4 battery: about 1,280 Wh stored, about 1,000 Wh usable, and about one day of autonomy for an average van. For more, add batteries in parallel following the manufacturer's instructions.
- Read the watt-hours or the voltage on the datasheet.
- Count on 80% usable energy, unless the manufacturer says otherwise.
- Check the maximum recommended charging current.
- Have the installation checked by a professional.
Sources
- Victron Energy, blog: lithium-ion (LFP) batteries versus AGM
- Victron Energy, Wiring Unlimited: DC wiring
- Dometic CFX3 25: product sheet, consumption at 32 °C
Safety. This guide is for information only and replaces neither the manufacturer's instructions nor a professional's advice. For 230 V, high currents and any fixed installation, call a qualified professional.